Milwaukee
Milwaukee Tool 4-in-1 1000V Insulated Slim Tip Multi-Bit Screwdriver
- SKU:
- MLW48-22-2216
- Availability:
- Usually Ships Same Day
- Weight:
- 0.82 LBS
Description
DUTY®
4-in-1 Slim-Tip Driver
Insulated Multi-Bit
Swap insulated tips for the required fastener while keeping a single 1,000 V-rated hand-driver system.
Product Overview
Use the 1,000 V-rated driver’s flush insulated tips for recessed access and controlled turning.
The barrel grip supports handling; marked bits and a carrying case organize the components.
- Insulated system1,000 V tool rating.
- Recessed accessFlush slim-tip insulation.
- Marked bitsSize identification on each tip.
- Carrying caseOrganized component storage.
Technical Specifications
- Voltage rating
- 1,000 V
- Tip profile
- Slim, flush insulation
- Handle
- Barrel grip
- Storage
- Carrying case
- Bit identification
- Size marked
- Test references
- IEC 60900 / ASTM F1505
Choose the Correct Fit
De-energize and verify the circuit is safe. Follow the qualified-person procedure and use the required protective equipment.
Inspect every insulated bit and the handle before use. Remove any cut, cracked, burned or damaged component from service.
Installation & Care
Use only the specified insulated components for this driver. Fully seat the chosen bit; do not substitute an ordinary bare bit.
Keep the driver clean and dry, and return components to the case. Do not grind insulation away for extra clearance.
Small Details. Big Jobsite Energy.
Get set. Stay focused. Make your next move count.
THE NEXT JOB.
Ask Willy:
Need to match an insulated driver? Tell Willy the screw profile, size and required reach so the tool fit can be checked.
Important Product Questions
Which insulated bits are included?
Phillips #2, 1/4 in cabinet, 3/16 in cabinet and square #2.
Can I use any replacement bit?
Use only an approved insulated replacement for the exact driver. A mechanically similar ordinary bit does not preserve the insulation of the system.
Does the 1,000 V rating permit energized work?
No. The rating describes the tool insulation. Isolate the circuit and follow electrical safety procedures; the tool does not replace training or required protective equipment.
