Milwaukee
Milwaukee Tool 8-in-1 1000V Insulated Precision Multi-Bit Screwdriver
- SKU:
- MLW48-22-2217
- Availability:
- Usually Ships Same Day
- Weight:
- 0.49 LBS
Description
DUTY®
8-in-1 Driver
Insulated Precision
Swap insulated tips for the required fastener while keeping a single 1,000 V-rated hand-driver system.
Product Overview
A 360° rotating cap aids fine control on small screws, with a non-slip handle for turning.
Size-marked bits aid profile selection; a case keeps the 1,000 V insulated parts organized.
- Insulated system1,000 V tool rating.
- Fine control360° rotating cap.
- Marked bitsSize-marked bit tips.
- Carrying caseOrganizes insulated parts.
Technical Specifications
- Voltage rating
- 1,000 V
- Back cap
- 360° rotation
- Handle
- Non-slip grip
- Storage
- Carrying case
- Bit identification
- Size marked
- Test references
- IEC 60900 / ASTM F1505
Choose the Correct Fit
De-energize and verify the circuit is safe. Follow the qualified-person procedure and use the required protective equipment.
Inspect every insulated bit and the handle before use. Remove any cut, cracked, burned or damaged component from service.
Installation & Care
Use only the specified insulated components for this driver. Fully seat the chosen bit; do not substitute an ordinary bare bit.
Keep the driver clean and dry, and return components to the case. Do not grind insulation away for extra clearance.
Small Details. Big Jobsite Energy.
Get set. Stay focused. Make your next move count.
THE NEXT JOB.
Ask Willy:
Need to match an insulated driver? Tell Willy the screw profile, size and required reach so the tool fit can be checked.
Important Product Questions
Which insulated bits are included?
Phillips #00 and #0; slotted 1/8 and 3/32 in; T7H, T8H, T10H and T15H.
Can I use any replacement bit?
Use only an approved insulated replacement for the exact driver. A mechanically similar ordinary bit does not preserve the insulation of the system.
Does the 1,000 V rating permit energized work?
No. The rating describes the tool insulation. Isolate the circuit and follow electrical safety procedures; the tool does not replace training or required protective equipment.
