Valves

Adjustable Pressure Relief Valve 1/2" x 1/2" (100/51#) Adjustable 50-200 PSI Cast brass body (100 per case) Click here for Technical Data

Cast Brass Angle Valve Standard installation trim and drain valves for the Fire Sprinkler Industry Water, oil or gas - 200 psi Rising stem Click here for Techn

3-Way Gauge Valve 1/4"" IPS Permits inspector to check accuracy or replace gauge without shutting down entire line 200 psi Click here for Technical Data

Sight Glass 1" IPS with restricted orifice. Flow indicator with 1/2" restricted orifice for inspector's test flow of 200 psi. Click Here for Tech Data ...

OS&Y Gate Valve Ductile Iron Body Flanged UL Listed / FM Approved Design Standard: AWWA Connection Ends: Flange to ASME B16.1 CL 125 Stem drive by keys, parallel or diagonal square or flat head...

SWING CHECK VALVE RUBBER SEAT 200# PSI Built for a tight seal on backflow Water, oil & gas - 200 PSI 1/2" to 2" IPS Cast Brass Construction NOT recommended...

Argco Test and Drain Valve Female NPT Inlet and Outlet Forged Brass Body Large, integral sight glass on each side Brass Finish Ball with Teflon Seats 1/2" (nominal) test...

Automatic Ball Drip Valve 1/2" x 1/2" Used to drain low point of system between check valve & Fire Department connection. Automatically seals under pressure. Must be...

1" Residential Riser with Basic TrimThe Residential Riser is a cost effective factory assemble riser assembly and comes in three configurations to meet all of your needs. This...

1/4" IPS Globe Valve Rubber seat 200 psi WOG Click here for Technical Data

Trim only package for 2" Riser Check Package Includes: 1" Angle Valve 200#, Two Fire Sprinkler Gauges Air/Water UL/ FM, 1/4" Inspectors Test 3-Way Valve, 1" x Close Nipple,...

Fire Protection System Sensor Residential Riser 1" w/Pressure ReliefThe Residential Riser is a cost effective factory assemble riser assembly and comes in three configurations to...

3/8" IPS forged ball valve 600# full port UL listed CSA & CGA approved Click here for Technical Data

Fire Protection OS&Y Gate Valve C.I. Body Grooved 2-1/2" UL/FM <

• Rated 300psi • Indoor/Outdoor use • Integral tamper switch • Eliminates water hammer • Slow open/Slow close • UL/FM Approved Click here for Technical Data<

Fire Protection System Sensor Residential Riser 1" with Pressure Relief and Test & Drain ValveThe Residential Riser is a cost effective factory assemble riser assembly and comes in...

FP Upright Post Indicator UL Listed/FM Approved Used to identify the position of buried Gate Valves (Post Indicator Valves) and are recommended for use in fire protection...

Ball Valve Lead Free 400# 3/4" NPT thread Standard Port UL Listed (10/90)

Lead Free Forged Brass Ball Valve 600# Full Port IPS UL Listed, CSA Approved Click here for Technical Data

Forged brass boiler drain 1/2" MIP x 3/4" Hose 200 WOG. Click here for Technical Data

3/4" IPS Gate Valve. 200# Full flow, 200 psi water, oil or gas. Non-rising stem, heavy duty handle, solid wedge disc. Click here for Technical Data ...

Hose Bibb 1/2" Male IPS x Hose Quarter Turn Brass Click here for Technical Data (PDF)

Rated 300psiIndoor/Outdoor useIntegral tamper switchEliminates water hammerSlow open/Slow closeUL/FM ApprovedClick here for Technical Data

Cast Brass Swing Check Valve Spring Loaded Clapper 4" x 4" Grooved Used to prevent reverse water flow into Fire Protection Systems Applicable for vertical or...

OS & Y Valve 1" IPS Model l8 Gate Valve. Exclusively crafted for the Lansdale International line. UL Listed/FM Approved @ 175 Lbs. UL # EX 6314 Bronze Screwed...

1" Residential Riser with Test & Drain ValveThe Residential Riser is a cost effective factory assemble riser assembly and comes in three configurations to meet all of your needs...

Inline Check Valve Cast Brass Spring loaded, Buna-N Seat Horizontal or Vertical installation Click here for Technical Data (PDF)

System Sensor Riser Manifold GROOVED 2" w/Pressure Relief Made in USA Click here for Technical Data (PDF)

Commercial Riser Assembly for Commercial Applications with System Sensor Water Flow Switch (Made in USA)+Test & Drain Valve (UL/FM)+Pressure Relief Trim+Bronze Grooved Butterfly...

Commercial Riser Assembly for Commercial Applications with System Sensor Water Flow Switch (Made in USA+Test & Drain Valve (UL/FM)+Bronze Grooved Butterfly Valve (UL/FM)+Ductile Iron...

Commercial Riser Riser Manifold for Commercial ApplicationsBasic Trim with Test & Drain ValveMade in USAClick here for Technical Data (PDF)

Provides the test and express drain functions for wet fire sprinkler systems on multi-story installations requiring pressure relief (NFPA 13 and NFPA 13R). Features a Pressure...