B54G-P100 - In-Line Sight Glass Replacement Glass

Product Highlights

• Genuine Dixon replacement component
• Manufacturer part number B54G-P100
• 1" in-line sight glass replacement insert
• Borosilicate glass construction
• Designed for compatible Dixon B54BMP-series in-line sight glasses
• Transparent viewing section for visual process monitoring
• Polycarbonate replacement option: B54BMP-LX100
• Nitrile rubber seal kit: B54BMP-SK100
• FKM seal kit: B54BMP-VK100
• Replacement glass only; not a complete sight glass assembly

The B54G-P100 is the borosilicate glass insert used as the transparent viewing section in compatible 1" Dixon B54BMP-series in-line sight glass assemblies.

It is intended as a replacement component when an existing glass insert requires replacement because of damage, wear, maintenance, or scheduled servicing.

This part is the glass insert only and should not be confused with the complete in-line sight glass assembly.

B54G-P100 is manufactured from borosilicate glass. Dixon uses borosilicate glass as the viewing material in its B54BMP-series sanitary in-line sight glass assemblies.

The transparent insert provides a clear viewing section through the process line, allowing operators to visually observe product flow, color, clarity, and other process conditions while the sight glass remains installed.

Material suitability should always be confirmed for the actual process media, operating temperature, pressure, cleaning chemistry, sanitation procedures, and surrounding environment.

Before ordering B54G-P100, confirm that the existing assembly is a compatible 1" Dixon B54BMP-series in-line sight glass and that a borosilicate glass insert is required.

Dixon uses different replacement insert part numbers for different sight glass sizes. B54G-P100 is specifically identified for the 1" configuration and should not be selected solely by comparing the physical appearance of the existing insert.

If a polycarbonate viewing insert is required instead of borosilicate glass, Dixon identifies B54BMP-LX100 as the corresponding 1" replacement. The compatible replacement seal kits are B54BMP-SK100 for nitrile rubber and B54BMP-VK100 for FKM.

Before servicing the sight glass, fully isolate the process line and confirm that the system has been safely depressurized, drained, and brought to a safe temperature according to applicable facility procedures.

Inspect the replacement glass before installation. Do not install glass with chips, cracks, scratches, impact damage, or other defects that could affect safe operation.

Inspect mating components and seals during disassembly and replace worn or damaged components as required. Use only gasket materials compatible with the process media, temperature, cleaning chemicals, and operating conditions.

During reassembly, ensure the glass and sealing components are properly positioned and avoid uneven mechanical loading on the glass. Follow the applicable Dixon installation and maintenance instructions for the complete sight glass assembly.

After reassembly, inspect the installation and verify leak-free operation under appropriate conditions before returning the process line to normal service.