Milwaukee
Milwaukee Tool 5Pk Pr2 Collator Bits
- SKU:
- MLW48-30-1000
- Availability:
- Usually Ships Same Day
- Weight:
- 0.30 LBS
Description
DUTY®
PR2 Collated
Magazine Bits
Replacement reduced Phillips #2 bits for the 49-20-0001 collated magazine attachment.
Product Overview
The 5.8-inch length serves the specified collated-feed setup rather than a general short-bit holder.
Choose these replacement bits when the collated-feed attachment specifies the PR2 tip.
- Dedicated fitFits the specified magazine.
- Reduced tipReduced PH2 tip geometry.
- Tool-steel durabilityS2 steel for driving.
- Service convenienceCollated-feed replacements.
Technical Specifications
- Tip profile
- Phillips
- Tip size
- #2
- Tip geometry
- Reduced
- Bit length
- 5.8 in
- Material
- S2 tool steel
- Attachment fit
- 49-20-0001
Choose the Correct Fit
Confirm the magazine attachment is model 49-20-0001 before fitting a replacement. Follow its bit-change procedure.
Check the screws call for the reduced Phillips #2 tip. A different screw profile requires its specified bit.
Installation & Care
Disconnect power as directed by the tool instructions before changing the bit. Reassemble and verify retention before use.
Inspect the tip if screws start slipping or driving inconsistently. Replace a damaged bit and check the screw feed and alignment.
Small Details. Big Jobsite Energy.
Get set. Stay focused. Make your next move count.
THE NEXT JOB.
Ask Willy:
Need help checking the fit? Tell Willy your tool, accessory and working dimensions so the GetPipe team can help.
Important Product Questions
Will these fit every collated screwdriver?
They are specified for attachment 49-20-0001. Match that attachment model rather than choosing by overall length alone.
Can I use a regular Phillips #2 bit instead?
Use the bit format required by the collated attachment, including its reduced geometry and length. An ordinary PH2 bit may not fit the feed system.
Will a fresh bit solve every feeding problem?
No. Check the screw strip, feed mechanism, alignment and depth setting as well. A replacement bit addresses tip wear, not every tool or screw issue.
