Milwaukee
Milwaukee Tool 3" Pre-Stressed Diamond Wet Core Bit
- SKU:
- MLW48-17-1030
- Availability:
- Usually Ships Same Day
- Weight:
- 8.00 LBS
Description
DUTY®
Pre-Stressed
Wet Core Bit
This 3 in diamond core bit is made for the particular demands of wet drilling in pre-stressed concrete.
Product Overview
This 3 in diamond bit wet-cores pre-stressed concrete with a 15 in drilling depth.
Close segment gaps help limit snagging on pre-tensioned cables or wire mesh during coring.
- Close segment gapsHelp limit cable snagging.
- Diamond cuttingDiamond cutting surface.
- Wet operationUses coring water supply.
- Pre-stressed workPre-stressed concrete use.
Technical Specifications
- Diameter
- 3 in
- Drilling depth
- 15 in
- Connection thread
- 1-1/4-7
- Drilling mode
- Wet
- Cutting material
- Diamond
- Application
- Pre-stressed concrete
Choose the Correct Fit
Match the 3 in opening to the sleeve or service clearance required, then check the drill’s rated core capacity.
Have the proposed hole location and any tendon or reinforcement conflicts cleared by the responsible structural professional before drilling.
Installation & Care
Isolate the drill before fitting or removing the bit. Follow the drill’s setup instructions and provide the specified water supply.
Allow the bit to cool before handling it. Clean out debris and inspect the cutting rim and threads before the next use.
Small Details. Big Jobsite Energy.
Get set. Stay focused. Make your next move count.
THE NEXT JOB.
Ask Willy:
Need help planning the core setup? Send Willy the required opening and depth, concrete type, drill model and spindle connection.
Important Product Questions
Does this bit make it safe to drill through tendons?
No. A bit intended for pre-stressed concrete does not authorize tendon cutting. Have the hole location and structural implications checked before any drilling.
Can I run it dry?
No. This model is a wet core bit. Follow the core drill’s instructions for water supply and collection.
Will the thread fit my core drill?
This bit uses a 1-1/4-7 connection. Check the spindle or approved adapter as well as the drill’s capacity for a 3 in core.
