Milwaukee
Milwaukee Tool 3/8 Inch Drive 8mm Long Ball End Hex Bit Socket
- SKU:
- MLW45-34-1101
- Availability:
- Usually Ships Same Day
- Weight:
- 0.22 LBS
Description
DUTY®
8 mm Ball-End
Hex Bit Socket
An 8 mm ball-end hex bit socket in a 6-inch long-reach format, matched to a 3/8-inch square-drive hand tool.
Product Overview
Use the 8 mm ball-end hex tip on matching recessed fasteners; the 6-inch body extends reach.
Align the 3/8-inch drive tool with the socket and allow room for the handle’s full stroke.
- Anti-roll flatsHelps resist rolling.
- Wrench-ready sidesWrench-compatible flats.
- Angled entryAngled entry up to 25°.
- Readable sizingLaser-engraved sizes.
Technical Specifications
- Drive size
- 3/8 in
- Bit size
- 8 mm
- Tip style
- Ball-end hex
- Length
- 6 in
- Angled access
- Up to 25°
- Finish
- Chrome-plated
Choose the Correct Fit
Match the 8 mm ball-end hex tip to the fastener. Clear debris from the recess and seat the bit fully before turning.
Use a 3/8-inch drive hand tool and check that the socket is retained. Allow room for both the socket and handle travel.
Installation & Care
Keep angled entry within the stated 25-degree limit. Reduce the angle whenever access allows and avoid sideways levering.
Wipe the bit clean after use and store it dry. Replace a socket with a chipped, twisted or badly worn tip before continuing.
Small Details. Big Jobsite Energy.
Get set. Stay focused. Make your next move count.
THE NEXT JOB.
Ask Willy:
Need a different reach or tip style? Tell Willy your fastener size and access restrictions so the GetPipe team can help match a socket.
Important Product Questions
What should I check before choosing this socket?
Confirm the fastener uses an 8 mm ball-end hex recess and that your hand tool has a 3/8-inch drive. Check body clearance as well as tip fit.
How much angled access does the ball end allow?
The ball-end design supports angled entry up to 25 degrees. Keep the tip fully engaged and work as close to straight-on as access permits.
Can I turn it with a wrench?
Yes. FOUR FLAT outer sides are wrench-compatible. Use a wrench that fits the flats securely; the bit size is not the external wrench size.
