Milwaukee
Milwaukee Tool 10" .325" LOW PROFILE™ Pitch, .043" Gauge Saw Chain and Guide Bar Set
- SKU:
- MLW49-16-2844
- Availability:
- Usually Ships Same Day
- Weight:
- 1.12 LBS
Description
DUTY®
10 in Bar
& Chain Set
A 10 in bar-and-chain set with .325 in LOW PROFILE pitch and .043 in gauge.
Product Overview
The A041 tail-mount set is recommended for saw 3013-20. Match all bar and chain dimensions.
A narrow-kerf, low-profile chain uses a multi-axis grind; the lightweight bar aids maneuvering.
- Matched dimensions.325 in pitch; .043 in gauge.
- Tail mountA041 mounting pattern.
- Low-profile chainNarrow-kerf chain format.
- Recommended saw3013-20.
Technical Specifications
- Nominal length
- 10 in
- Chain pitch
- .325 in LOW PROFILE
- Chain gauge
- .043 in
- Tail mount
- A041
- Saw fit
- 3013-20
- Kerf design
- Narrow
Choose the Correct Fit
Confirm the saw’s required pitch, gauge, bar length, tail mount and drive-link count. Matching only the length is not enough to establish compatibility.
Isolate the saw from power before removing the bar or chain. Wear the protective equipment specified for handling sharp chain cutters.
Installation & Care
Install the chain in the correct direction and set tension and lubrication exactly as the saw manual directs. Check free movement before operation.
Inspect the chain, bar rails and nose regularly. Retension and maintain the chain according to the saw instructions and replace damaged parts.
Small Details. Big Jobsite Energy.
Get set. Stay focused. Make your next move count.
THE NEXT JOB.
Ask Willy:
Send Willy the saw model and required pitch, gauge, length and drive-link count to confirm the bar-and-chain set.
Important Product Questions
Which saw is this set recommended for?
Recommended for Milwaukee 3013-20. Verify the saw’s required bar and chain specifications before installation.
Is the A041 mount alone enough to confirm fit?
No. Pitch, gauge, length and drive-link count must also match the saw’s requirements.
What gauge is this version?
This set is specified with .043 in gauge. Do not substitute a different gauge without the saw manufacturer’s approval.
