69NAB64VS - Air Brake Male Elbow

Designed for use in air brake systems or cab controls

• Machined from CA260, CA345 or CA377 brass
• Pre-applied thread sealant
• Thread sealant may be white or burnt orange

Positive grip

• Cut tubing squarely- maximum of 15° angle allowable.
• Check that port or mating part is clean and free of debris.
• Insert tubing into fittings until it bottoms on seat.
• Tighten nut with wrench until one thread remains visible on the fittings body; (this will allow for a number of remakes) or, the nut should be screwed down finger tight, then wrench-tightened according to the tube size used.

• Meets D.O.T FMVSS 571.106 and SAE J246
• Ref. SAE 100202 BA

• Utilize ribbed sleeve for compression and positive grip
• Compatible tubing: SAE J844 type A and B