Milwaukee
Milwaukee Tool EXACT 1-3/8" SINK Knockout Set
- SKU:
- MLW49-16-2702
- Availability:
- Usually Ships Same Day
- Weight:
- 6.13 LBS
Description
DUTY®
Sink Knockout
7/8 & 1-3/8 in Set
Prepare sink openings with matched EXACT punches and dies, ball-bearing draw studs and a hand-ratchet setup.
Product Overview
Use the matched 7/8- and 1-3/8-inch EXACT sink pairs on stainless steel up to 16 gauge.
Die crosshairs locate the cut; punch teeth split slugs and die ports provide removal access.
- Sink sizing7/8 and 1-3/8 in openings.
- Close-clearance work5° ratcheting action.
- Clear alignmentVisible die crosshairs.
- Slug removalSplitting teeth and die ports.
Technical Specifications
- Hole sizes
- 7/8 and 1-3/8 in
- Stainless limit
- 16 gauge
- Drive
- Hand ratchet
- Ratchet angle
- 5°
- Draw studs
- 3/8 and 3/4 in
- Alignment
- Die crosshairs
Choose the Correct Fit
Check the sink fitting’s required opening, material and thickness. Use the matching sink punch and die.
Select the appropriate draw stud and pilot-hole preparation for the chosen cutting pair. Follow the complete kit instructions.
Installation & Care
Secure the work, hand-tighten the assembly and keep fingers clear. Use the ratchet without adding unapproved leverage.
Clear the slug and inspect the cutting pair after each hole. Keep the threads and die alignment marks clean.
Small Details. Big Jobsite Energy.
Get set. Stay focused. Make your next move count.
THE NEXT JOB.
Ask Willy:
Need a sink-cutting kit? Tell Willy the hole diameters, sink material and thickness required by your fittings.
Important Product Questions
Which punch-and-die sizes are included?
The official contents list includes 7/8 and 1-3/8 in sink punches and dies, 3/8 and 3/4 in ball-bearing studs, and 5/16 and 1/2 in cobalt drill bits.
What stainless thickness is supported?
The product page rates the sink-punch setup for up to 16 gauge stainless steel. Verify material and setup before cutting.
What helps in a confined space?
Milwaukee specifies 5° ratcheting action, allowing the ratchet to advance with a short swing. Leave enough clearance to keep the setup aligned and your hands safe.
