Milwaukee
Milwaukee Tool 3/4" Draw Stud
- SKU:
- MLW49-16-2681
- Availability:
- Usually Ships Same Day
- Weight:
- 1.00 LBS
Description
DUTY®
3/4 in
Draw Stud
Build a 3/4–2 in conduit-punch setup with the 3/4 in standard threaded draw stud.
Product Overview
For the 2676-20, this 3/4 in stud serves 3/4–2 in conduit punches; the sizes differ.
The threaded stud pulls the punch through the die; match the full assembly before use.
- Stud diameter3/4 in connection size.
- 2676-20 conduit fit3/4–2 in punch sizes.
- Threaded jointStandard draw-stud setup.
- Mounting choiceQuick Connect or direct.
Technical Specifications
- Stud size
- 3/4 in
- Conduit sizes
- 3/4–2 in
- Pilot hole
- 7/8 in
- Tool reference
- 2676-20
- Connection
- Threaded
- Mounting
- Quick Connect or direct
Choose the Correct Fit
Use the manual’s exact 3/4–2 in conduit punch/die rows. The 3/4 in stud size is not the finished hole size.
For 2676-20 direct mounting, remove the Quick Connect assembly and hand-tighten the standard stud securely into the piston.
Installation & Care
Prepare the 7/8 in pilot hole specified for this stud diameter. Remove the battery before assembling the cutting components.
Inspect threads and locking surfaces before each setup. Keep fingers away from the punch and die and clear the slug after cutting.
Small Details. Big Jobsite Energy.
Get set. Stay focused. Make your next move count.
THE NEXT JOB.
Ask Willy:
Need a draw-stud match? Give Willy the tool model, punch and die part numbers, and the conduit opening you need.
Important Product Questions
Is this a complete knockout cutting set?
The draw stud connects the cutting components. Match it with the correct punch, die and tool; these parts are not interchangeable solely by nominal size.
Can it mount directly in the tool?
The 2676-20 manual permits its standard stud to thread directly into the piston after removing the Quick Connect assembly. Follow that tool’s setup instructions.
What does the conduit range describe?
It identifies the 3/4–2 in conduit punch sizes listed with this stud in the 2676-20 table. It does not specify sheet thickness or finished hole diameter.
