Milwaukee
Milwaukee Tool Guide Plate for 1-1/2" Thick Wall Core Bit
- SKU:
- MLW48-20-5168
- Availability:
- Usually Ships Same Day
- Weight:
- 0.01 LBS
Description
DUTY®
Thick Wall
Core Guide Plate
Start a 1-1/2 in opening with the guide plate matched to core body 48-20-5125 and centering pin 48-20-5199.
Product Overview
This plastic guide steadies the 1-1/2-inch thick-wall core body at the start of the hole.
Match it to core body 48-20-5125 and centering pin 48-20-5199 for the starting cut.
- Steadier startsHelps reduce core-bit walk.
- Plastic guideSupports the starting cut.
- Size-specific fitMatches the core diameter.
- Center-pin supportUses the matched center pin.
Technical Specifications
- Core diameter
- 1-1/2 in
- Core body fit
- 48-20-5125
- Centering pin
- 48-20-5199
- Wall system
- Thick wall
- Guide material
- Plastic
- Hammer system
- SDS-Max / Spline
Choose the Correct Fit
Match this plate to core body 48-20-5125, not just a similarly sized bit. Confirm the thick wall design and 1-1/2 in diameter.
Use centering pin 48-20-5199 with the correct adapter shank for the hammer. Check the complete core assembly before starting.
Installation & Care
Isolate the hammer while fitting the guide and pin. Follow the core-bit instructions for forming the initial groove and removing the guide assembly.
Inspect the plastic plate for cracks, wear or distortion. Replace a damaged plate before it can compromise the next hole start.
Small Details. Big Jobsite Energy.
Get set. Stay focused. Make your next move count.
THE NEXT JOB.
Ask Willy:
Need help matching a replacement guide? Send Willy the core-body part number, diameter and whether the bit is thin wall or thick wall.
Important Product Questions
Can a guide plate of the same diameter fit a different core system?
Do not assume it will. This plate is matched to thick wall core body 48-20-5125; verify the body and centering pin together.
Does the plate replace the centering pin?
No. It works with centering pin 48-20-5199. Check that both matched components are available for the starting operation.
Should the guide stay installed for the whole hole?
Follow the core-bit starting procedure. The guide and pin position the initial cut; remove them when instructed before continuing to the required depth.
