Milwaukee
Milwaukee Tool 8" Angled Head Diagonal Cutting Pliers
- SKU:
- MLW48-22-6528
- Availability:
- Usually Ships Same Day
- Weight:
- 0.66 LBS
Description
DUTY®
8" Angled Diagonal
Dipped Grip Cutters
An 8-inch angled diagonal cutter with dipped grips and induction-hardened blades for wire cutting where head access matters.
Product Overview
Position the angled head for the cut and leave room for a controlled handle stroke.
Check wire size and material against cutting limits; jaw opening does not give capacity.
- Hardened edgesInduction-hardened.
- Angled accessAngled cutting head.
- Forged constructionForged for regular use.
- Rust protectionRust-resistant finish.
Technical Specifications
- Nominal length
- 8 in
- Head form
- Angled diagonal
- Edge treatment
- Induction-hardened
- Handle grip
- Dipped
- Construction
- Forged
- Surface protection
- Rust-resistant
Choose the Correct Fit
Use the exact cutting or gripping area intended for the task. Avoid prying or twisting sideways with the cutting edges.
Verify wire size and material against the manufacturer’s limits. Do not use jaw opening as a substitute for a cutting-capacity rating.
Installation & Care
De-energize and verify circuits before wire work. Do not infer electrical insulation from a colored or covered handle.
Clean the pivot and inspect cutting edges for chips or misalignment. Support the offcut and wear eye protection when clipping wire.
Small Details. Big Jobsite Energy.
Get set. Stay focused. Make your next move count.
THE NEXT JOB.
Ask Willy:
Need help choosing? Tell Willy your material, required size and working clearance so the GetPipe team can check the fit.
Important Product Questions
Can I cut hardened screws or steel cable?
Verify the exact material, diameter and hardness rating before cutting. A tool described for wire does not automatically cover every screw, steel cable or hardened fastener.
Are covered grips enough for electrical work?
Grip covering is not proof of an insulation rating. De-energize and verify the circuit, and follow the required electrical-safety procedure.
How do I keep a close cut controlled?
Support the work and offcut, position the edge squarely and apply controlled hand pressure. Do not twist the edge against the remaining material to break off a cut.
